Why is my Cr-10 is not reading files sliced on a the new Cura?
Have either of you seen or tried the Creality camera? And do you know if it works with the Creality WiFi box?
Just pre ordered OCULUS QUEST 2 VR Headset Kit that can CAST Media to my 72″TV. Just wondered if you could Recommend the best Casting Unit to Purchase?
Have you guys heard about the fact that printing from Octoprint will yield lower quality prints than printing directly from SD?
I just installed a micro swiss All Metal direct drive kit on a Ender 5 pro, Problem: Extruder is stripping the filament, and yes I did run the Gcode from Micro swiss to adjust the E-Steps.
