What did we answer this week?

Do you think there will be a 64 bit 3D printer motherboard?

​Bryan, what’s the last word on the amount of memory in the new SKR Mini E3

​After a couple of hours of printing on CR10s my Z axis is out. what is the best way to get the 2 motors to stay the same?

I want to print something solid where do i change this?

Hey Guys i am looking for a good setting to print TPU on Ender 3 with hemera direct drive and Anycubic Chiron anyone have any suggestions?

I print with PLA with the nozzle at 225 and bed at 90. On prints that go away from the center of the bed, the middle of the first layer peels up. Any solutions?

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *