What did we answer this week?

I am wondering why my BIGTREETECH TFT35 V3.0 is not working on the latest version of Marlin 2.0 but the second I take it down to a lower version it works?

I was wondering what fan I could use to replace the fan on the hotend of my Cr 10 v2?

​I was also wondering what a good direct drive and hotend would be good for a Cr 10 v2 and a Cr 10s pro v2?

Would using a layer of glue stick on the bed be enough to keep the PETG from bonding with the bed or should I use something like masking tape?

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *