Do you think there will be a 64 bit 3D printer motherboard?

​Bryan, what’s the last word on the amount of memory in the new SKR Mini E3

​After a couple of hours of printing on CR10s my Z axis is out. what is the best way to get the 2 motors to stay the same?

I want to print something solid where do i change this?

Hey Guys i am looking for a good setting to print TPU on Ender 3 with hemera direct drive and Anycubic Chiron anyone have any suggestions?

I print with PLA with the nozzle at 225 and bed at 90. On prints that go away from the center of the bed, the middle of the first layer peels up. Any solutions?

​Have you ever messed with a custom variant of Marlin called Cheetah 5.0?

What is your favorite build plate for an Ender 3 sized printer?

Ender 5 Plus plate is warped beyond belief. 

PEI sheet on mirrored glass?

PETG stringing. why does a slower retraction speed help?

recommendation for an all metal hot end for an Ender 5 Plus?

And so many more.

What did we answer this week?

New silent board mainboard fan does not start until print calling fan starts

Is there written instructions to update the firmware on the mainboard and on the display

Bigtree TECH SKR V1.4 / With 5xTMC2209 V1.2 and a  Bigtree SKR MINI E3 32 Bit Control Board Integrated TMC2209 UART for my CR-10S

There are hundreds of parts and such you can put on your 3d printer to “upgrade it”. Is it worth my time to install them?

 Vertical line problem

Creality CR10S, motherboard 2.0 Creality, and marlin firmware is it possible to decrease the micro-stepping in the X and Y axle?

I have solid bed mounts, can I replace the tightening wheels with locking nuts and bolts?

My BLtouch doesn’t probe the bed correctly for some points at startup. What should I do to make it always work correctly?