Can you recommend a video on how to get your first layer right?

Should I change my start G Code to Heat-up my Nozzle at the same as the bed? Your Opinion?

I’m about to change my stock extruder to a duel gear. My question is am I going to have to calibrate my esteps or just try a small print first?

To improve quality is it worth replacing stock motors off of a Creality or Anycubic to LDO-branded 0.9 degree ones ?

What would be the best filament to use for an RC Catamaran speed boat?

How do I get my first layer perfect for 3D printing?

Can I upgrade my CR – 10S with a SKR Mini E3?

Question for you all, I updated my 1.3 SKR and ever since I’ve done that I cannot see the board on my computer so I cannot update it anymore it shows it on the computer but with no SD card showing up.

Hey I have a nonsticking bed any recomondation?

If you have a lPC1769 processor on the board you have to issue M22 first to see the sd card show up as a USB device?

Do you think the ender 3 glass heated bed will work on the mingda 2d?

Is it worth replacing all moving wires with silicon wire to avoid usage stress?

I upgraded my cr-10 to a direct drive the one that you all recommended on thingiverse and now I’m having some issues looking like it’s under excluding didn’t know if I needed to change my esteps?

Do you have any tips for stopping filament twisting in the bowden tube and causing the extruder to jump and grind the filament?

Is there a difference between an 8 bit and 32 bit board?

I’m upgrading a bunch of printers to 32 bit boards; there were still quite a few bugs in Merlin 2.0 that affected print quality. Would you stick to 1.X for now ?

Printing abs with my cr-10s pro in a enclosure getting a little warpage, using simpllif3d, any advice would be appreciated.

I am new at 3D printing, I have an Artillery sidewinder x1 new version. Do you have any recommendations as to the setting for printing with PETG?. 

What’s your opinion on Rep Rap firmware?