What are some of the questions were answered this week?

In “vase mode” using Cura. What I can do to find a balance between time to print and thickness of the vase. Is there a trick? 

If you have a new out of the box printer, you want to change the nozzle, do you need to heat up the nozzle still or can it be done cold?

I’m replacing a part cooling fan on E3V2. Existing wiring is blue/yellow. New fan is black/red. Which goes to which? 

CR10s is having adhesion problems and print curling? What most likely is the problem?

Trying to create a flat 1mm rectangular sheet with some rows of evenly spaced 8mm holes no thicker than the sheet, but with strength on each circumference. Can I manage that with Matter tools?

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *