What are some of the questions we answered this week?

Can you recommend a video on how to get your first layer right?

Should I change my start G Code to Heat-up my Nozzle at the same as the bed? Your Opinion?

I’m about to change my stock extruder to a duel gear. My question is am I going to have to calibrate my esteps or just try a small print first?

To improve quality is it worth replacing stock motors off of a Creality or Anycubic to LDO-branded 0.9 degree ones ?

What would be the best filament to use for an RC Catamaran speed boat?

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *