What are some of the questions we answered this week?

Bed Bilinear levelling in Marlin. Mine start at front right. Is there a start like front left as it is X=0 & y=0?

After a couple of months of great prints, the last few prints it is doing a layer shift every so often randomly. my belt is tight and seems fine?

Heat Bed Insulation and the Reflective foil tape, is it any good?

​I have an Ender 5 with a Titan extruder. Would it be possible to print NinjaFlex through the bowden tube? Or, should I wait until I can afford a direct drive?

Layer shifting, do you need to do some printer Mantainence.

Similar Posts