My CR10 every time that you move the bed side to side you can feel something like a bump.
My new Ender 5 has no option for setting Z Offset in Prepare or Control menus. Do I need to change something in the firmware?
I have the stock 10S pro V2, is it worth upgrading anything to improve the use of the printer?
Got a high spot on my glass bed right in the middle. Any suggestions on a workaround?
My CR10S Pro does not stop lowering on the Z even if I put my finger under the stock sensor. The light comes on but no one home?
Is it OK to extend the thermistor wires to be able to get all electronics out of my abs printer enclosure? All other wires should be OK to extend.
