Is there a difference between an 8 bit and 32 bit board?
I’m upgrading a bunch of printers to 32 bit boards; there were still quite a few bugs in Merlin 2.0 that affected print quality. Would you stick to 1.X for now ?
Printing abs with my cr-10s pro in a enclosure getting a little warpage, using simpllif3d, any advice would be appreciated.
I am new at 3D printing, I have an Artillery sidewinder x1 new version. Do you have any recommendations as to the setting for printing with PETG?.
What’s your opinion on Rep Rap firmware?
