So, what do you think of the anycubic Chiron printer?
My prints dont stick what do I do?
Question for you all what does it mean when I print one model it comes out very clean no layer lines but when I plant a different model I can see a layer lines all through it and it’s the same PLA?
I have an ender 3 v2 and added a bltouch with the smith3d firmware. When I run the bed visualizer in octoprint, it seems to come back with different measurements each time!
On my endstop. I thought it was crashing into the endstop. On the x gantry. But it turned out to be I had the belt too tight. It would not let the carriage go all the way to the endstop.
How to you level the middle of the bed my corners are perfect but the middle is way to close and there is no middle knob?
